RPi IR-CUT Camera

Raspberry Pi IR-CUT Camera sku:450888

Introduction

The IR-CUT Camera is compatible with all generations of Raspberry Pi(Pi 3 Model B/ Pi 2B/ B+/ A+/ Zero), available at both day and night.

Features

Compatible with any generations of Raspberry Pi.
With built-in IR-CUT, it can fix the chromatic aberration problem when use in day, and has better image.
Support IR night vision with the IR Fill light.
Support adjustable focusing.

How to toggle working mode?

Tow working mode: normal mode and night mode;

The default working mode is normal model for RPi IR-CUT.

Run command:

sudo nano /boot/config.txt

append the following line at the end of file:

disable_camera_led=1

save and reboot, then the camera working on night mode;

if you want to restore to normal node, only you need to comment the line:

#disable_camera_led=1

You can program GPIO to toggle the working mode.

high - normal mode

low - night mode

Parameter

5 Megapixel
CCD Dimension: 1/4 inch
Aperture (F) : 1.8
Focal Length: 2.6mm (Adjustable)
Sensor best solution: 1080p
4 screw holes: used for both attachment;

Support 3.3V power supply; 
Support infrared LED and fill flash.

Dimension: 31mm x 32 mm

Packing List

1 x RPi IR-CUT Camera
1 x 16 PIN FFC (reverse)

Document

The CMOS: File:OV5647-Sensor.pdf

Enable comment auto-refresher

Anonymous user #5

57 months ago

Score 0

We have a Raspberry Pi Kamera/5MP 8mm Brennweite Nachtsicht NoIR Kamera Board mit IR-CUT für Raspberry Pi 3 modell B/2B/B +/Null (w) We did sudo nano /boot/config.txt append the following line at the end of file:

disable_camera_led=1

save and reboot, no change. What should we do now?

Permalink | Reply

Anonymous user #4

63 months ago

Score 0

Where to find a full list of commands? With attributs like -w -h -t etc. The official RPi camera is descibed very detail. Are the commands from this source valid for your camera?

Permalink | Reply