PoE HAT (C)

Overview

PoE HAT (C) is a Power over Ethernet (PoE+) expansion board for Raspberry Pi 3B+/4B , supporting IEEE 802.3af/at network standard. If you have a PoE router or switch that supports the IEEE 802.3af/at network standard, then take me and you only need a network cable to connect to your Raspberry Pi to achieve networking and power supply.

Features

Standard Compliance : IEEE 802.3af & 802.3at (PoE+)

Input Voltage Range : 36–57V DC

Device Classification : Class 4

Dual Output Power Rails :

5V DC / 5A (25W max) delivered via the 40-pin GPIO header.

12V DC /2.1A (25W max) delivered via a dedicated 2-pin XH2.54 connector.

Note:Total maximum combined output is 25w (subject to input power limits).

Fully Isolated Power Supply: Utilises isolated Switching Mode Power Supply (SMPS) topology for safety and reliability

Simplified Cabling: Single cable simultaneously addresses power delivery and network connectivity, providing robust power for peripherals

Technical Specification

Power supply	36-57VDC powering over Ethernet
Power output	5.1V 2.5A/12V 1.1A @IEEE 802.3af 5.1V 5.0A/12V 2.1A @IEEE 802.3at
Ports & Connectors	PoE input interface: 2x2-pin header x1 GPIO expansion interface: 2x20-pin header x1 12V output interface: 2-pin XH2.54 connector x1
Dimension	65×43.2×22.1mm (L×W×H)

Packing List

X15-POE1 board x1

screw pack x1(for securing to IO Hat)

User Manual

Hardware Installation: X15-POE1 Hardware

FAQ

Q1: Question 1

A: Place the answer here.