CommentStreams:E5ebe0bbe91e5711c1a14b987c4d31ff

Hi,

I hope you are doing well. We bought more than 40 pieces of these UPS and facing power issues.

I am reaching out for your assistance in troubleshooting an issue where my Jetson Nano turns ON without any input power supplied to the Geek T201 1-Cell 18650 UPS. This issue consistently occurs after a day or two.

During my investigation, I conducted tests under the following conditions:

No connection was made to Pins 1 and 2 of the AL ON header. No connection was made to Pins 3 and 4 of the PWR SW header. However, when a floating wire was brought near or connected to Pin 2, 3, or 4 under these conditions, the Geek UPS indicator LEDs and the Jetson Nano turned ON unexpectedly. This behavior has been observed multiple times across two different setups.

I would appreciate your insights into understanding the root cause of this issue and any recommendations for resolving it.

Looking forward to your response.

Best regards,