CommentStreams:Ed5a2001f53a6fc6f0f03216eac63dd2

Hello, it's me again.

Nevermind, the NV2 seems to be incompatible too. This manufacturer is known for swapping chips from batch to batch, and I maybe I got the Phison controller if I can judge correctly:

drk@drk-pi:~ $ sudo nvme id-ctrl -H /dev/nvme0n1

NVME Identify Controller:

vid       : 0x2646

ssvid     : 0x2646

sn        : 50026B7686C65AD9    

mn        : KINGSTON SNV2S1000G                     

fr        : SBM02106

rab       : 6

ieee      : 0026b7

cmic      : 0

  [3:3] : 0     ANA not supported

  [2:2] : 0     PCI

  [1:1] : 0     Single Controller

  [0:0] : 0     Single Port


mdts      : 6

cntlid    : 0x1

ver       : 0x10400

rtd3r     : 0x186a0

rtd3e     : 0x13880

oaes      : 0x200

  [31:31] : 0   Discovery Log Change Notice Not Supported

  [27:27] : 0   Zone Descriptor Changed Notices Not Supported

  [15:15] : 0   Normal NSS Shutdown Event Not Supported

  [14:14] : 0   Endurance Group Event Aggregate Log Page Change Notice Not Supported

  [13:13] : 0   LBA Status Information Notices Not Supported

  [12:12] : 0   Predictable Latency Event Aggregate Log Change Notices Not Supported

  [11:11] : 0   Asymmetric Namespace Access Change Notices Not Supported

  [9:9] : 0x1   Firmware Activation Notices Supported

  [8:8] : 0     Namespace Attribute Changed Event Not Supported


ctratt    : 0

  [19:19] : 0   Flexible Data Placement Not Supported

  [15:15] : 0   Extended LBA Formats Not Supported

  [14:14] : 0   Delete NVM Set Not Supported

  [13:13] : 0   Delete Endurance Group Not Supported

  [12:12] : 0   Variable Capacity Management Not Supported

  [11:11] : 0   Fixed Capacity Management Not Supported

  [10:10] : 0   Multi Domain Subsystem Not Supported

  [9:9] : 0     UUID List Not Supported

  [8:8] : 0     SQ Associations Not Supported

  [7:7] : 0     Namespace Granularity Not Supported

  [6:6] : 0     Traffic Based Keep Alive Not Supported

  [5:5] : 0     Predictable Latency Mode Not Supported

  [4:4] : 0     Endurance Groups Not Supported

  [3:3] : 0     Read Recovery Levels Not Supported

  [2:2] : 0     NVM Sets Not Supported

  [1:1] : 0     Non-Operational Power State Permissive Not Supported

  [0:0] : 0     128-bit Host Identifier Not Supported


rrls      : 0

cntrltype : 1

  [7:2] : 0     Reserved

  [1:0] : 0x1   I/O Controller

fguid     : 00000000-0000-0000-0000-000000000000

crdt1     : 0

crdt2     : 0

crdt3     : 0

nvmsr     : 0

  [1:1] : 0     NVM subsystem Not part of an Enclosure

  [0:0] : 0     NVM subsystem Not part of an Storage Device


vwci      : 0

  [7:7] : 0     VPD Write Cycles Remaining field is Not valid.

  [6:0] : 0     VPD Write Cycles Remaining 


mec       : 0

  [1:1] : 0     NVM subsystem Not contains a Management Endpoint on a PCIe port

  [0:0] : 0     NVM subsystem Not contains a Management Endpoint on an SMBus/I2C port


oacs      : 0x16

  [10:10] : 0   Lockdown Command and Feature Not Supported

  [9:9] : 0     Get LBA Status Capability Not Supported

  [8:8] : 0     Doorbell Buffer Config Not Supported

  [7:7] : 0     Virtualization Management Not Supported

  [6:6] : 0     NVMe-MI Send and Receive Not Supported

  [5:5] : 0     Directives Not Supported

  [4:4] : 0x1   Device Self-test Supported

  [3:3] : 0     NS Management and Attachment Not Supported

  [2:2] : 0x1   FW Commit and Download Supported

  [1:1] : 0x1   Format NVM Supported

  [0:0] : 0     Security Send and Receive Not Supported


acl       : 4

aerl      : 7

frmw      : 0x12

  [5:5] : 0     Multiple FW or Boot Update Detection Not Supported

  [4:4] : 0x1   Firmware Activate Without Reset Supported

  [3:1] : 0x1   Number of Firmware Slots

  [0:0] : 0     Firmware Slot 1 Read/Write


lpa       : 0x12

  [6:6] : 0     Telemetry Log Data Area 4 Not Supported

  [5:5] : 0     LID 0x0, Scope of each command in LID 0x5, 0x12, 0x13 Not Supported

  [4:4] : 0x1   Persistent Event log Supported

  [3:3] : 0     Telemetry host/controller initiated log page Not Supported

  [2:2] : 0     Extended data for Get Log Page Not Supported

  [1:1] : 0x1   Command Effects Log Page Supported

  [0:0] : 0     SMART/Health Log Page per NS Not Supported


elpe      : 63

  [7:0] : 63 (0's based)        Error Log Page Entries (ELPE)


npss      : 4

  [7:0] : 4 (0's based) Number of Power States Support (NPSS)


avscc     : 0x1

  [0:0] : 0x1   Admin Vendor Specific Commands uses NVMe Format


apsta     : 0x1

  [0:0] : 0x1   Autonomous Power State Transitions Supported


wctemp    : 356

 [15:0] : 83°C (356 Kelvin)     Warning Composite Temperature Threshold (WCTEMP)


cctemp    : 363

 [15:0] : 90°C (363 Kelvin)     Critical Composite Temperature Threshold (CCTEMP)


mtfa      : 100

hmpre     : 16384

hmmin     : 16384

tnvmcap   : 0

[127:0] : 0

        Total NVM Capacity (TNVMCAP)


unvmcap   : 0

[127:0] : 0

        Unallocated NVM Capacity (UNVMCAP)


rpmbs     : 0

 [31:24]: 0     Access Size

 [23:16]: 0     Total Size

  [5:3] : 0     Authentication Method

  [2:0] : 0     Number of RPMB Units


edstt     : 10

dsto      : 1

fwug      : 4

kas       : 0

hctma     : 0x1

  [0:0] : 0x1   Host Controlled Thermal Management Supported


mntmt     : 303

 [15:0] : 30°C (303 Kelvin)     Minimum Thermal Management Temperature (MNTMT)


mxtmt     : 389

 [15:0] : 116°C (389 Kelvin)    Maximum Thermal Management Temperature (MXTMT)


sanicap   : 0x60000002

  [31:30] : 0x1 Media is not additionally modified after sanitize operation completes successfully

  [29:29] : 0x1 No-Deallocate After Sanitize bit in Sanitize command Not Supported

    [2:2] : 0   Overwrite Sanitize Operation Not Supported

    [1:1] : 0x1 Block Erase Sanitize Operation Supported

    [0:0] : 0   Crypto Erase Sanitize Operation Not Supported


hmminds   : 0

hmmaxd    : 256

nsetidmax : 0

endgidmax : 0

anatt     : 0

anacap    : 0

  [7:7] : 0     Non-zero group ID Not Supported

  [6:6] : 0     Group ID does change

  [4:4] : 0     ANA Change state Not Supported

  [3:3] : 0     ANA Persistent Loss state Not Supported

  [2:2] : 0     ANA Inaccessible state Not Supported

  [1:1] : 0     ANA Non-optimized state Not Supported

  [0:0] : 0     ANA Optimized state Not Supported


anagrpmax : 0

nanagrpid : 0

pels      : 1

domainid  : 0

megcap    : 0

sqes      : 0x66

  [7:4] : 0x6   Max SQ Entry Size (64)

  [3:0] : 0x6   Min SQ Entry Size (64)


cqes      : 0x44

  [7:4] : 0x4   Max CQ Entry Size (16)

  [3:0] : 0x4   Min CQ Entry Size (16)


maxcmd    : 0

nn        : 1

oncs      : 0x9f

  [8:8] : 0     Copy Not Supported

  [7:7] : 0x1   Verify Supported

  [6:6] : 0     Timestamp Not Supported

  [5:5] : 0     Reservations Not Supported

  [4:4] : 0x1   Save and Select Supported

  [3:3] : 0x1   Write Zeroes Supported

  [2:2] : 0x1   Data Set Management Supported

  [1:1] : 0x1   Write Uncorrectable Supported

  [0:0] : 0x1   Compare Supported


fuses     : 0

  [0:0] : 0     Fused Compare and Write Not Supported


fna       : 0

  [3:3] : 0     Format NVM Broadcast NSID (FFFFFFFFh) Supported

  [2:2] : 0     Crypto Erase Not Supported as part of Secure Erase

  [1:1] : 0     Crypto Erase Applies to Single Namespace(s)

  [0:0] : 0     Format Applies to Single Namespace(s)


vwc       : 0x7

  [2:1] : 0x3   The Flush command supports NSID set to FFFFFFFFh

  [0:0] : 0x1   Volatile Write Cache Present


awun      : 255

awupf     : 0

icsvscc   : 1

  [0:0] : 0x1   NVM Vendor Specific Commands uses NVMe Format


nwpc      : 0

  [2:2] : 0     Permanent Write Protect Not Supported

  [1:1] : 0     Write Protect Until Power Supply Not Supported

  [0:0] : 0     No Write Protect and Write Protect Namespace Not Supported


acwu      : 0

ocfs      : 0

  [1:1] : 0     Controller Copy Format 1h Not Supported

  [0:0] : 0     Controller Copy Format 0h Not Supported


sgls      : 0

 [15:8] : 0     SGL Descriptor Threshold

 [1:0]  : 0     Scatter-Gather Lists Not Supported


mnan      : 0

maxdna    : 0

maxcna    : 0

subnqn    : nqn.2021-03.com.kingston:nvme:nvm-subsystem-sn-50026B7686C65AD9

ioccsz    : 0

iorcsz    : 0

icdoff    : 0

fcatt     : 0

  [0:0] : 0     Dynamic Controller Model


msdbd     : 0

ofcs      : 0

  [0:0] : 0     Disconnect command Not Supported


ps      0 : mp:5.00W operational enlat:0 exlat:0 rrt:0 rrl:0

            rwt:0 rwl:0 idle_power:- active_power:-

            active_power_workload:-

ps      1 : mp:3.50W operational enlat:0 exlat:200 rrt:1 rrl:1

            rwt:1 rwl:1 idle_power:- active_power:-

            active_power_workload:-

ps      2 : mp:2.50W operational enlat:0 exlat:1000 rrt:2 rrl:2

            rwt:2 rwl:2 idle_power:- active_power:-

            active_power_workload:-

ps      3 : mp:1.50W non-operational enlat:5000 exlat:5000 rrt:3 rrl:3

            rwt:3 rwl:3 idle_power:- active_power:-

            active_power_workload:-

ps      4 : mp:1.50W non-operational enlat:20000 exlat:70000 rrt:4 rrl:4

            rwt:4 rwl:4 idle_power:- active_power:-

            active_power_workload:- 

----

I've now spent $127 for NVMe's only to make it work...