Difference between revisions of "Solar Panel Battery Regulator Controller"

Latest revision as of 14:16, 8 April 2020

Solar Panel Battery Regulator Controller

Make sure your battery has enough voltage for the controller to recognize the battery type before first installation.
The battery cable should be as short as possible to minimize loss.
The regulator is only suitable for Lead Acid Batteries: OPEN,AGM, GEL. It is not suited for Nickel Metal Hydride, Lithium Ions or Other Batteries.
The charge regulator is only suitable for regulating solar modules. Never connect another charging source to the charge regulator.

Build-in industrial micro controller.
Big LCD display,all adjustable parameter.
Fully 3-stage PWM charge management.
Build-in short-circuit protections,open-circuit protections,reverse protections,over-load protections.
Dual USB output
Dual MOS Reverse current protections ,low heat productions.

Connect the battery to the charge regulator plus and minus.it will show 1 ,if it detects 12V battery, 2 if it detects 24V battery.
Connect the photovoltaic module to the regulator plus and minus.
Connect the consumer to the charge regulator plus and minus. The reverse order applies when deinstalling! An improper sequence order can damage the controller!

Only For offGrid PV Solar System.
For 10A 12V Pv System: 120W Solar Panel,12V Leadacid Battery,21V for Max input Voltage
For 10A 24V Pv System: 240W Solar Panel,24V Leadacid Battery,42V for Max input Voltage

[[User Manual]|