X450: Difference between revisions

← Older edit Newer edit →

VisualWikitext

@@ Line 13: / Line 13: @@
 |-
 | FOR USE WITH ||
-*Jetson Nano
+*Raspberry Pi 1 Model B+/ 2 Model B / 3 Model B / 3 Model B+
 |-
 | OPERATING SYSTEM ||
-*All operating systems
+*Moode Audio Player
+*OSMC
+*Openelec
+*Raspbian Jessie
+*Volumio
+*Pi Core Player
 |-
 | KEY FEATURES ||
@@ Line 31: / Line 36: @@
 *LED blue indicator indicates drive status
 |-
-| POWER SUPPLY ||
+| Specification ||
-*Power supply via DC jack: 5VDC ±5%.
+*Power supply: 6-26Vdc，≥3A recommended
-*A good quality power supply is required, otherwise the hard disk will not be recognized or the system will automatically shut down.THIS IS VERY IMPORTANT!!
+*GPIO used : LRCK - IO19, BCK - IO18, DATA - IO21, IR - IO26, AMP mute - IO22
-|-
+*Analog audio input level via onboard headphone jack : 2V RMS
-| I/O PORTS ||
+*Amplifier max output power: 2×100W at 4Ω BTL Load at 21Vdc
-*USB Type-A socket x 1
+*Resolution/Sampling Rate: upto 24bit / 192KHz (Raspberry Pi I2S)
-*DC Jack  5.5x2.1mm x 1
+*PCB size 87 x 56mm
-*22Pin SATA socket x 1
 |-
 | DIMENSION ||
@@ Line 44: / Line 48: @@
 |-
 |  NOTE ||
-*2.5 inch SATA SSD is not included, Not compatible with M.2 SATA SSDs, M.2 PCIe AHCI SSDs, or other M.2 non-NVMe devices
+<span class="tb_red">WARNING: Do not apply power to your Raspberry Pi via the PI's Micro USB socket.</span>
-*As with all SSDs, new media must be formatted before use
-*Performance depends on host system, workload, and SSD media used
-*SSD will run hot when it is under heavy load
-*Older SSD drives with less efficient flash media may not perform as well as newer drives
 |}