Difference between revisions of "X1100 software"

From Geekworm Wiki
Jump to navigation Jump to search
 
(No difference)

Latest revision as of 12:46, 8 December 2023

Important! Increases the USB current limit to 1.6A

By default, USB boot is not enabled with a 3A power supply or some third-party USB-PD capable power supply. If you are using a power supply that cannot provide 5A at +5V or not compatible, the current draw to USB peripherals will be restricted to 600mA and it might affect USB booting or cannot provide enough power to your hard drives and SSDs .[1]


It is required that increases the USB current limit for peripherals to 1.6A by setting usb_max_current_enable=1 in the /boot/firmware/config.txt file will override this and enable USB boot with a lower wattage power supply.


Open then Teminal window, then run the following command to open the /boot/firmware/config.txt file:

sudo nano /boot/firmware/config.txt

Add a line at the end of the file that reads like this:

usb_max_current_enable=1

X1100-setting1.jpg

Save and exit. In Nano editor, you do that by hitting CTRL + X, answering Y and hitting Enter when prompted.

Reboot the Raspberry Pi

sudo reboot

You can check the status of power output to the USB ports using vcgencmd.

vcgencmd get_config usb_max_current_enable

X1100-setting2.jpg

This means that the USB current limit has been increased to 1.6A - Success!


In addition, regarding the operation of SSD, you can refer to: How to Format and Mount the HDD/SSD on Raspberry Pi


Return to X1100


References:

Add your comment
Geekworm Wiki welcomes all comments. If you do not want to be anonymous, register or log in. It is free.