X1207

Safety Instructions & Warnings

• You must read these safety instructions and warnings before charging your batteries.
• Lithium Polymer and Li-ion batteries are volatile. Failure to read and follow the below instructions may result in fire, personal injury and damage to property if charged or used improperly.
• Never make wrong polarity connection when charging and discharging battery packs. Always double check polarity of battery's connector to make sure "+" to "+" and "-" to "-".
• Do not mix and use old batteries and new batteries, or batteries with different brand names.
• Lithium batteries has it's cycle life, please replace old battery with new one when it reaches it's service life or when it is two year old, whichever comes first.
• When charging Battery Pack, please put battery in a fire proof container. Please don't leave the UPS shield on the wood material or carpet and unattended.

Overview

The X1207 is a PoE-powered UPS HAT designed for Raspberry Pi 5, delivering reliable 5.1V/5A backup power to maintain uninterrupted operation. It supports high-demand setups and complies with IEEE 802.3af/at PoE standards, drawing up to 25W from a compatible POE switch while providing both power and network connectivity over a single cable.

With intelligent power management, it monitors Pi status, cuts power after shutdown to conserve battery, and features ultra-low standby consumption. The board ensures seamless power switching during outages and supports auto power-on and AC loss detection.

Technical specification

Power input	35-57VDC powering over Ethernet 5Vdc 5A via USB-C
UPS output	5.1V ±5% Max 5A
Battery charging current	1.5A
Terminal Battery Voltage	4.23V
Battery Recharge Threshold	4.1V
Ports & Connectors	4-pin POE female header x1 USB-C power in connector x1 1-cell 21700 battery connector x1 40-pin extended GPIO header x1
PCB Size	86.5mm x 84.5mm

Packing List

• X1207 V1.2 UPS board x 1
• Spacer M2.5 F/F 13.5mm x 4
• Screw M2.5x5mm x 8
• Pogo pin x 1 (For connecting to the Pi 5 PSW through hole)