X1017: Difference between revisions

(3 intermediate revisions by one other user not shown)

Line 3:

*Never connect both DC power and ATX 4-pin power simultaneously: mixing these two power supply methods will directly burn out the expansion board and hard drive.

* Automatic Drive Power Cut-off: Supported with DC jack power input only. Not available when using ATX 4-pin connector.

* Warning: Over-voltage will damage your HDD. Please use a stable 12V power supply within the specified range.

* The X1017 is designed for data storage purposes and does not currently support booting from HDD/SSD with the existing firmware.

* The 4-pin functional fan connector only supports 12V PWM fans. Connecting a 5V fan will immediately burn it out.

* Do not apply power to your Raspberry Pi via the Type-C USB socket.

Line 58:

Line 56:

|'''Recommended power supply via 4-pin ATX connector'''||

* '''12V 20A'''

⚠️ WARNING: ~~Do NOT connect both DC~~ power ~~and ATX 4-pin power simultaneously. Mixing these two power methods will permanently destroy the board and~~ connected ~~devices~~.

⚠️ CRITICAL WARNING: Only one external power source should be connected at a time.

|-

Line 123:

Line 121:

[[Category:Product Manual]]

[[Category:Raspberry pi]]

~~[[Category:Knowledge]]~~

~~[[Category:Orange Pi]]~~

~~[[Category:Arduino]]~~

~~[[Category:Consumer Electronics]]~~

~~[[Category:DIY Electronics]]~~

~~[[Category:ESP32]]~~

~~[[Category:Jetson Nano]]~~

~~[[Category:LattePanda]]~~

~~[[Category:Smart Home]]~~

@@ Line 3: / Line 3: @@
 <font color=red>
-*Never connect both DC power and ATX 4-pin power simultaneously: mixing these two power supply methods will directly burn out the expansion board and hard drive.
 * Automatic Drive Power Cut-off: Supported with DC jack power input only. Not available when using ATX 4-pin connector.
 * Warning: Over-voltage will damage your HDD. Please use a stable 12V power supply within the specified range.
 * The X1017 is designed for data storage purposes and does not currently support booting from HDD/SSD with the existing firmware.
-* The 4-pin functional fan connector only supports 12V PWM fans. Connecting a 5V fan will immediately burn it out.
 * Do not apply power to your Raspberry Pi via the Type-C USB socket.</font>
@@ Line 58: / Line 56: @@
 |'''Recommended power supply via 4-pin ATX connector'''||
 * '''12V 20A'''
-<font color=red>⚠️ WARNING: Do NOT connect both DC power and ATX 4-pin power simultaneously. Mixing these two power methods will permanently destroy the board and connected devices.</font>
+<font color=red>⚠️ CRITICAL WARNING: Only one external power source should be connected at a time.</font>
 |-
@@ Line 123: / Line 121: @@
 [[Category:Product Manual]]
 [[Category:Raspberry pi]]
-[[Category:Knowledge]]
-[[Category:Orange Pi]]
-[[Category:Arduino]]
-[[Category:Consumer Electronics]]
-[[Category:DIY Electronics]]
-[[Category:ESP32]]
-[[Category:Jetson Nano]]
-[[Category:LattePanda]]
-[[Category:Smart Home]]
 <!--Please choose the  -->
 <!--Remove other categories, just keep the appropriate categories -->