HDMI to LVDS

User Manual

• Hardware Installation:
• How to make it work:

FAQ

Q1: Question 1

A: Place the answer here.

Add your comment

Geekworm Wiki welcomes all comments. If you do not want to be anonymous, register or log in. It is free.

Sort by date Sort by score

Enable comment auto-refresher

You are ignoring the author of this comment

Show comment | Manage ignore list

Anonymous user #2

8 days ago

Score 0

Is it possible to configure this for 1024x768 at 30 FPS?

Permalink | Reply

You are ignoring the author of this comment

Show comment | Manage ignore list

Ruby

7 days ago

Score 0

Hi there! Please kindly refer to User Manual （https://wiki....1-EN.pdf） Page 5 - section "d) HDMI Built-in EDID Preferred Resolution Modification Command" for details.

Is it possible to configure this for 1024x768 at 30 FPS? == Yes, it supports a resolution of 1024×768 @ 60Hz.

Permalink

You are ignoring the author of this comment

Show comment | Manage ignore list

Anonymous user #1

10 days ago

Score 0

Is it possible to configure the LVDS bit-depth by sending UART commands? It is set to 8-bit, but I'd like to change it to 6-bit.

Permalink | Reply

You are ignoring the author of this comment

Show comment | Manage ignore list

Ruby

8 days ago

Score 0

Hi there! Please kindly refer to User Manual （https://wiki....1-EN.pdf） Page 6 - section "f) LVDS 6bit/8bit Output Mode Setting Command" for details.

LVDS 6bit/8bit Output Mode Setting Command

Input: test 103 id

Click "Send Data". The command is successful if the receive window displays the following. Reboot the board afterward:

cmd=103, p0=0, p1=0, p2=0

bit mode id=0x00, please re-start the board.

Note: Parameter "id" only accepts values 0 or 255.

0 = LVDS 6bit mode

255 = LVDS 8bit mode

The default LVDS output mode is 8bit

Permalink