Changes

← Older edit

Enable pikvm hdmi audio

3 bytes added, 17 June

no edit summary

This article describes how to enable hdmi audio on the Geekworm PiKVM hardware such as [[X650]] / [[X680]] / [[PiKVM-A3]] etc , you can refer to [https://docs.pikvm.org/audio/ pikvm official audio tutorial] also.

~~<pre>~~

Unlike the official PiKVM V3 version, the Geekworm KVM hardware supports audio output by default and does not require additional jumper settings. But if you can't use audio, here are a few reasons to consider:

1Geekworm KVM hardware supports audio output by default and does not require additional jumper settings. But if you can't use audio, here are a few reasons to consider:* It is possible that your HDMI does not support the audio channel, consider replacing the HDMI cable.2. * It is possible that the motherboard of the controlled computer does not support audio output via HDMI, if so, you cannot use audio unless you replace the motherboard;3. * Did you use a VGA to HDMI adapter to get the HDMI signal?* Refer to https://docs.pikvm.org/audio/ for more details and technical limitations related to audio.~~</pre>~~

Harry

Bureaucrats, Comment administrators, Interface administrators, Administrators

5,374

edits