5,253
edits
Changes
Jump to navigation
Jump to search
Please read [[Raid Instruction]] firstly. You can freely choose the four RAID modes supported by this device by setting the jumper cap.
no edit summary
This guide describes how to do RAID setting, and it only applies to [[X882]],[[X885]],[[NASPi Gemini 3.5]] or [[NASPi Gemini 2.5]] or * X882 is the storage shield of [[X882NASPi Gemini 2.5]] Shield* X885 is the storage shield of [[NASPi Gemini 3.5]]
'''Warning''' : Please backup your data before setup and switch, otherwise you maybe lost your data.
Please read [[Raid Instruction]] firstly. You can freely choose the four RAID modes supported by this device by setting the jumper cap.
Start your setup , please strictly follow the steps below:;
'''1. Assemble your device'''，refer to the '''installation video''' of the corresponding device to assemble, only the top cover is not installed, because you need to use the onboard buttons^_^.
: <span class="tb_red">PS: USB connector must be insert</span>
'''2. Choose <u>Disconnect power supply</u>, and choose your Raid setting, insert or remove your jumper by the following jumper instruction:'''
* For '''RAID0''' setting, Both '''A''' and '''B''' jumpers need to be shorted
* For '''RAID1''' setting, Only the '''B''' jumper needs to be shorted
</pre>
There are two HDDs/SSDs devices were found. (/dev/sda and /dev/sdb) to '''PM ''' model;
Or
<pre>
NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINT
/dev/sda 8:0 0 298.1G 0 disk
└─/dev/sda 8:1 0 298.1G 0 part
/dev/mmcblk0 179:0 0 7.4G 0 disk
├─/dev/mmcblk0p1 179:1 0 256M 0 part /boot
└─/dev/mmcblk0p2 179:2 0 7.1G 0 part /
</pre>
There is '''ONLY one''' HDD/SSD devices is found. (/dev/sda) to '''RAID1''' or '''RAID0''' model;
'''[NOTE]'''：
3. Or run <code>lsusb</code> and <code>lsblk</code>, and then send us the results to email: support@geekworm.com
'''Introduction to LED flashing when setting raid on X882 / X885 shield'''
https://www.youtube.com/shorts/ZoNHahaMqXs
<!--
{{#ev:youtube|https://www.youtube.com/shorts/ZoNHahaMqXs}}
-->
'''FAQ'''