Difference between revisions of "X1100 Hardware"

From Geekworm Wiki
Jump to navigation Jump to search
 
(No difference)

Latest revision as of 00:23, 8 December 2023

02-X1100-V1.0-hardware.jpg

[Required hardware]

  1. X1100 USB3.0 to SATA HDD/SSD shield
  2. Raspberry Pi 5 Model B
  3. 16GB micro-SD card x1 (Optional)
  4. 27W USB-C Power Supply

[Hardware installation]

1. Insert the SSD into the SATA socket. Make sure it’s lined up with the corresponding holes underneath before screwing it into position

X1100v1.0-install1.jpg

2. Push four M2.5 screws down through themounting hole and screw four spacers(M2.5x14mm) down until it is hand tight.

X1100v1.0-install2.jpg

3. Four M2.5 screws to screwdown the Raspberry Pi 5

X1100v1.0-install3.jpg

4. Insert the USB jumper into the USB connector

X1100v1.0-install4.jpg


Return to X1100

Add your comment
Geekworm Wiki welcomes all comments. If you do not want to be anonymous, register or log in. It is free.