Open main menu
Geekworm Wiki

Changes

X630-Hardware-Reset

374 bytes added, 16:28, 27 June 2023
First, we recommend that you read [https://www.raspberrypi.org/app/uploads/2013/07/RaspiCam-Documentation.pdf Raspberry Pi camera applications document]
 
'''For Hardware Reset''' - Starting RASPISTILL or RASPIVID once then reboot your Raspberry Pi.
==Use GStreamer Tools ==
You need an accessory board ([[X630#X630-A2]]) for audio capturing.
 
Please refer to [[CSI-2-Software]] if you are use the '''Raspberry Pi Bullseye OS'''
 
==Use RASPISTILL RASPIVID ==
Only for OS before Rasberry Pi Bullseye OS such as '''Raspberry Pi Buster OS'''
 
1. Update & upgrade the raspberry pi system (It will take a long time depend on the different country)
sudo apt-get update
sudo apt-get upgrade
 
2. Enable camera module (the camera is enabled by default in Raspberry pi Bullseys OS)
sudo raspi-config
Navigate to ''''Interfacing Options'''' and hit Enter. Now select the ''''Camera'''' option, and hit the Enter key to enable it. Select “Finish” and select to '''reboot''' your Raspberry Pi.
 
3. Edit /boot/config.txt to add the line (that will need sudo, and use 'sudo nano /boot/config.txt')
dtoverlay=tc358743
to the end of the file.
(Please use when operating system cannot control the X630 module via GPIO509)4. Reboot. If all is well you should get a /dev/video0 device.<pre>pi@raspberrypi:~ $ ls /dev/video0/dev/video0</pre>
134. To take a photo with the X630 Module
raspistill -o image.jpg
Here, "image" is the name of your image that will be saved to your Raspberry Pi
145. If you need to take second image, then you will need to reboot the Raspberry Pi and execute the "raspistill" again
sudo reboot
155. To record a video with the X630 module
raspivid -o video.h264 -t 10000
Here, "video" is the name of your video and "10000" is the number of milliseconds.
167. If you need to record second video, then you will need to reboot the Raspberry Pi and execute the "raspivid" again
sudo reboot
<hr> ==Audio&Video capturing using GStreamer=='''For Hardware Reset''' - Starting RASPISTILL or RASPIVID once then reboot your Raspberry Pi Please use the following guide if your dip switch is changed Refer to 'Hardware reset' position.[[CSI Audio Video capturing using GStreamer]]
17. To take a photo with the X630 Module
raspistill -o image.jpg
Here, "image.jpg" is the name of your image that will be saved to your Raspberry Pi
 
18. If you need to take second image, then you will need to reboot the Raspberry Pi and execute the "raspistill" again.
sudo reboot
 
19. To record a video with the X630 module
raspivid -o video.h264 -t 10000
Here, "video" is the name of your video and "10000" is the number of milliseconds.
 
20. If you need to record second video, then you will need to reboot the Raspberry Pi and execute the "raspivid" again.
sudo reboot
<comments />
Retrieved from "https://wiki.geekworm.com/Special:MobileDiff/12894...16462"