Admin: Replace with

2026-05-27T02:13:25Z

Replace <comments/> with <comment-streams />

← Older revision		Revision as of 10:13, 27 May 2026
Line 43:		Line 43:

	<!--Add review function! -->		<!--Add review function! -->
	<comment-streams />		<comment-streams id="main" />

	<!--Please choose the -->		<!--Please choose the -->

Admin: Replace with

2026-05-26T12:07:32Z

Replace <comments/> with <comment-streams />

← Older revision		Revision as of 20:07, 26 May 2026
Line 43:		Line 43:

	<!--Add review function! -->		<!--Add review function! -->
	<~~comments~~ />		<comment-streams />

	<!--Please choose the -->		<!--Please choose the -->

Harry at 08:48, 2 August 2023

2023-08-02T08:48:34Z

New page

{{GD Template Impl}}
We test the following step base the Jetson nano image (ubuntu 18.04 LTS)

1. Update software source on Ubuntu, refer to [[Update software source on Ubuntu]]

'''NOTE''': You must connect the internet via Ethernet or [[Wireless USB adapter]] before software update.

2. To install pip for Python 3 on Ubuntu, run the following commands as root or sudo user in your terminal:
sudo apt-get update
sudo apt-get install python-pip
3. To install Jetson GPIO library:
sudo pip install Jetson.GPIO
4. To install I2C dev library
sudo apt-get install libi2c-dev i2c-tools
pip install smbus
5. To check what i2c devices connected (This is very important!!)
sudo i2cdetect -y -r 1
PS: The i2c address ix 0x3C

6. To install Nano editor on Ubuntu
sudo apt-get install nano
7. Download the sample python file ([[File:Bat.py]]) for i2c battery voltage & percentage reading, then run the following command to test it.
sudo python Bat.py
8. Download the sample python file ([[File:Pld.py]]) for AC power loss / power adapter failure detection, then run the following command to test it.
sudo python Pld.py

Note: you can get the sample python file from github also;
git clone https://github.com/geekworm-com/T208

'''FAQ'''

A: Found some error

Q:
1. check your python version with command 'sudo python -v'

2. check the I2C if is enable with command 'sudo i2cdetect -y -r 1', you can found the result is 0x36

3. Configure the appropriate software source, or you can't update.

Return to [[T208]]


<comments />




[[Category:Product Manual]]
[[Category:Jetson Nano]]
[[Category:Knowledge]]

T208-Software - Revision history

Admin: Replace with

Admin: Replace with

Harry at 08:48, 2 August 2023