Harry at 12:57, 26 May 2026

2026-05-26T12:57:18Z

Harry at 12:52, 26 May 2026

2026-05-26T12:52:29Z

← Older revision		Revision as of 20:52, 26 May 2026
Line 4:		Line 4:

	drk@drk-pi:~ $ sudo nvme id-ctrl -H /dev/nvme0n1		drk@drk-pi:~ $ sudo nvme id-ctrl -H /dev/nvme0n1
			<pre>
	NVME Identify Controller:		NVME Identify Controller:

Line 481:		Line 481:

	----		----
			</pre>
	I've now spent $127 for NVMe's only to make it work...		I've now spent $127 for NVMe's only to make it work...

	<!-- migrated from Comments; original IP: 185.204.53.98 -->		<!-- migrated from Comments; original IP: 185.204.53.98 -->

185.204.53.98: Migrated reply #5899

2025-07-08T22:53:22Z

Migrated reply #5899

New page

Hello, it's me again.

Nevermind, the NV2 seems to be incompatible too. This manufacturer is known for swapping chips from batch to batch, and I maybe I got the Phison controller if I can judge correctly:

drk@drk-pi:~ $ sudo nvme id-ctrl -H /dev/nvme0n1

NVME Identify Controller:

vid : 0x2646

ssvid : 0x2646

sn : 50026B7686C65AD9

mn : KINGSTON SNV2S1000G

fr : SBM02106

rab : 6

ieee : 0026b7

cmic : 0

[3:3] : 0 ANA not supported

[2:2] : 0 PCI

[1:1] : 0 Single Controller

[0:0] : 0 Single Port

mdts : 6

cntlid : 0x1

ver : 0x10400

rtd3r : 0x186a0

rtd3e : 0x13880

oaes : 0x200

[31:31] : 0 Discovery Log Change Notice Not Supported

[27:27] : 0 Zone Descriptor Changed Notices Not Supported

[15:15] : 0 Normal NSS Shutdown Event Not Supported

[14:14] : 0 Endurance Group Event Aggregate Log Page Change Notice Not Supported

[13:13] : 0 LBA Status Information Notices Not Supported

[12:12] : 0 Predictable Latency Event Aggregate Log Change Notices Not Supported

[11:11] : 0 Asymmetric Namespace Access Change Notices Not Supported

[9:9] : 0x1 Firmware Activation Notices Supported

[8:8] : 0 Namespace Attribute Changed Event Not Supported

ctratt : 0

[19:19] : 0 Flexible Data Placement Not Supported

[15:15] : 0 Extended LBA Formats Not Supported

[14:14] : 0 Delete NVM Set Not Supported

[13:13] : 0 Delete Endurance Group Not Supported

[12:12] : 0 Variable Capacity Management Not Supported

[11:11] : 0 Fixed Capacity Management Not Supported

[10:10] : 0 Multi Domain Subsystem Not Supported

[9:9] : 0 UUID List Not Supported

[8:8] : 0 SQ Associations Not Supported

[7:7] : 0 Namespace Granularity Not Supported

[6:6] : 0 Traffic Based Keep Alive Not Supported

[5:5] : 0 Predictable Latency Mode Not Supported

[4:4] : 0 Endurance Groups Not Supported

[3:3] : 0 Read Recovery Levels Not Supported

[2:2] : 0 NVM Sets Not Supported

[1:1] : 0 Non-Operational Power State Permissive Not Supported

[0:0] : 0 128-bit Host Identifier Not Supported

rrls : 0

cntrltype : 1

[7:2] : 0 Reserved

[1:0] : 0x1 I/O Controller

fguid : 00000000-0000-0000-0000-000000000000

crdt1 : 0

crdt2 : 0

crdt3 : 0

nvmsr : 0

[1:1] : 0 NVM subsystem Not part of an Enclosure

[0:0] : 0 NVM subsystem Not part of an Storage Device

vwci : 0

[7:7] : 0 VPD Write Cycles Remaining field is Not valid.

[6:0] : 0 VPD Write Cycles Remaining

mec : 0

[1:1] : 0 NVM subsystem Not contains a Management Endpoint on a PCIe port

[0:0] : 0 NVM subsystem Not contains a Management Endpoint on an SMBus/I2C port

oacs : 0x16

[10:10] : 0 Lockdown Command and Feature Not Supported

[9:9] : 0 Get LBA Status Capability Not Supported

[8:8] : 0 Doorbell Buffer Config Not Supported

[7:7] : 0 Virtualization Management Not Supported

[6:6] : 0 NVMe-MI Send and Receive Not Supported

[5:5] : 0 Directives Not Supported

[4:4] : 0x1 Device Self-test Supported

[3:3] : 0 NS Management and Attachment Not Supported

[2:2] : 0x1 FW Commit and Download Supported

[1:1] : 0x1 Format NVM Supported

[0:0] : 0 Security Send and Receive Not Supported

acl : 4

aerl : 7

frmw : 0x12

[5:5] : 0 Multiple FW or Boot Update Detection Not Supported

[4:4] : 0x1 Firmware Activate Without Reset Supported

[3:1] : 0x1 Number of Firmware Slots

[0:0] : 0 Firmware Slot 1 Read/Write

lpa : 0x12

[6:6] : 0 Telemetry Log Data Area 4 Not Supported

[5:5] : 0 LID 0x0, Scope of each command in LID 0x5, 0x12, 0x13 Not Supported

[4:4] : 0x1 Persistent Event log Supported

[3:3] : 0 Telemetry host/controller initiated log page Not Supported

[2:2] : 0 Extended data for Get Log Page Not Supported

[1:1] : 0x1 Command Effects Log Page Supported

[0:0] : 0 SMART/Health Log Page per NS Not Supported

elpe : 63

[7:0] : 63 (0's based) Error Log Page Entries (ELPE)

npss : 4

[7:0] : 4 (0's based) Number of Power States Support (NPSS)

avscc : 0x1

[0:0] : 0x1 Admin Vendor Specific Commands uses NVMe Format

apsta : 0x1

[0:0] : 0x1 Autonomous Power State Transitions Supported

wctemp : 356

[15:0] : 83°C (356 Kelvin) Warning Composite Temperature Threshold (WCTEMP)

cctemp : 363

[15:0] : 90°C (363 Kelvin) Critical Composite Temperature Threshold (CCTEMP)

mtfa : 100

hmpre : 16384

hmmin : 16384

tnvmcap : 0

[127:0] : 0

Total NVM Capacity (TNVMCAP)

unvmcap : 0

[127:0] : 0

Unallocated NVM Capacity (UNVMCAP)

rpmbs : 0

[31:24]: 0 Access Size

[23:16]: 0 Total Size

[5:3] : 0 Authentication Method

[2:0] : 0 Number of RPMB Units

edstt : 10

dsto : 1

fwug : 4

kas : 0

hctma : 0x1

[0:0] : 0x1 Host Controlled Thermal Management Supported

mntmt : 303

[15:0] : 30°C (303 Kelvin) Minimum Thermal Management Temperature (MNTMT)

mxtmt : 389

[15:0] : 116°C (389 Kelvin) Maximum Thermal Management Temperature (MXTMT)

sanicap : 0x60000002

[31:30] : 0x1 Media is not additionally modified after sanitize operation completes successfully

[29:29] : 0x1 No-Deallocate After Sanitize bit in Sanitize command Not Supported

[2:2] : 0 Overwrite Sanitize Operation Not Supported

[1:1] : 0x1 Block Erase Sanitize Operation Supported

[0:0] : 0 Crypto Erase Sanitize Operation Not Supported

hmminds : 0

hmmaxd : 256

nsetidmax : 0

endgidmax : 0

anatt : 0

anacap : 0

[7:7] : 0 Non-zero group ID Not Supported

[6:6] : 0 Group ID does change

[4:4] : 0 ANA Change state Not Supported

[3:3] : 0 ANA Persistent Loss state Not Supported

[2:2] : 0 ANA Inaccessible state Not Supported

[1:1] : 0 ANA Non-optimized state Not Supported

[0:0] : 0 ANA Optimized state Not Supported

anagrpmax : 0

nanagrpid : 0

pels : 1

domainid : 0

megcap : 0

sqes : 0x66

[7:4] : 0x6 Max SQ Entry Size (64)

[3:0] : 0x6 Min SQ Entry Size (64)

cqes : 0x44

[7:4] : 0x4 Max CQ Entry Size (16)

[3:0] : 0x4 Min CQ Entry Size (16)

maxcmd : 0

nn : 1

oncs : 0x9f

[8:8] : 0 Copy Not Supported

[7:7] : 0x1 Verify Supported

[6:6] : 0 Timestamp Not Supported

[5:5] : 0 Reservations Not Supported

[4:4] : 0x1 Save and Select Supported

[3:3] : 0x1 Write Zeroes Supported

[2:2] : 0x1 Data Set Management Supported

[1:1] : 0x1 Write Uncorrectable Supported

[0:0] : 0x1 Compare Supported

fuses : 0

[0:0] : 0 Fused Compare and Write Not Supported

fna : 0

[3:3] : 0 Format NVM Broadcast NSID (FFFFFFFFh) Supported

[2:2] : 0 Crypto Erase Not Supported as part of Secure Erase

[1:1] : 0 Crypto Erase Applies to Single Namespace(s)

[0:0] : 0 Format Applies to Single Namespace(s)

vwc : 0x7

[2:1] : 0x3 The Flush command supports NSID set to FFFFFFFFh

[0:0] : 0x1 Volatile Write Cache Present

awun : 255

awupf : 0

icsvscc : 1

[0:0] : 0x1 NVM Vendor Specific Commands uses NVMe Format

nwpc : 0

[2:2] : 0 Permanent Write Protect Not Supported

[1:1] : 0 Write Protect Until Power Supply Not Supported

[0:0] : 0 No Write Protect and Write Protect Namespace Not Supported

acwu : 0

ocfs : 0

[1:1] : 0 Controller Copy Format 1h Not Supported

[0:0] : 0 Controller Copy Format 0h Not Supported

sgls : 0

[15:8] : 0 SGL Descriptor Threshold

[1:0] : 0 Scatter-Gather Lists Not Supported

mnan : 0

maxdna : 0

maxcna : 0

subnqn : nqn.2021-03.com.kingston:nvme:nvm-subsystem-sn-50026B7686C65AD9

ioccsz : 0

iorcsz : 0

icdoff : 0

fcatt : 0

[0:0] : 0 Dynamic Controller Model

msdbd : 0

ofcs : 0

[0:0] : 0 Disconnect command Not Supported

ps 0 : mp:5.00W operational enlat:0 exlat:0 rrt:0 rrl:0

rwt:0 rwl:0 idle_power:- active_power:-

active_power_workload:-

ps 1 : mp:3.50W operational enlat:0 exlat:200 rrt:1 rrl:1

rwt:1 rwl:1 idle_power:- active_power:-

active_power_workload:-

ps 2 : mp:2.50W operational enlat:0 exlat:1000 rrt:2 rrl:2

rwt:2 rwl:2 idle_power:- active_power:-

active_power_workload:-

ps 3 : mp:1.50W non-operational enlat:5000 exlat:5000 rrt:3 rrl:3

rwt:3 rwl:3 idle_power:- active_power:-

active_power_workload:-

ps 4 : mp:1.50W non-operational enlat:20000 exlat:70000 rrt:4 rrl:4

rwt:4 rwl:4 idle_power:- active_power:-

active_power_workload:-

----

I've now spent $127 for NVMe's only to make it work...

CommentStreams:Ed5a2001f53a6fc6f0f03216eac63dd2 - Revision history

Harry at 12:57, 26 May 2026

Harry at 12:52, 26 May 2026

185.204.53.98: Migrated reply #5899