https://wiki.geekworm.com/index.php?action=history&feed=atom&title=CommentStreams%3A6212959e54c440a78918d50bcf888c6aCommentStreams:6212959e54c440a78918d50bcf888c6a - Revision history2026-07-25T14:59:35ZRevision history for this page on the wikiMediaWiki 1.43.8https://wiki.geekworm.com/index.php?title=CommentStreams:6212959e54c440a78918d50bcf888c6a&diff=35528&oldid=prev136.61.208.161: Migrated comment #62412026-01-24T07:12:52Z<p>Migrated comment #6241</p>
<p><b>New page</b></p><div>I'm hoping someone can help here. I tried to read around here and couldn't find a solution... I have an already setup raspi 4b which boots from ssd. There is no sd card. I have both an official power supply from raspi and a geekworm capable of 5A and 4A at more than 20W.<br />
<br />
When I tried to install it into this case and get it running, it kept looping from usb to sd trying to boot but was never able to. Here is the error screen, as best as I could grab it. I ended up typing all of this out so if there are typos, its mine.<br />
<br />
Raspberry Pi 4 Model B - 8GB<br />
bootloader: 69471177 2025/05/08<br />
update-ts: 1755048332<br />
<br />
board: rev d03115 0014 serial 4cf0723 d2:d8:72:u3:82:10<br />
boot: mode USB-MSD 4 order f14 retry 0/128 restart 28/-1<br />
SD: card not detected<br />
part: 1 mbr [0x0c:00004000 0x83:00104000 0x00:0000000 0x00:0000000]<br />
fw: start.elf fixup.dat<br />
net: down ip: 0.0.0.0 sn: 0.0.0.0 gw: 0.0.0.0<br />
tftp: 0.0.0.0 00:00:00:00:00:00<br />
display DISP0: HDMI HDP=1 EDID: ok #2 DISP1: HPD=0 EDID=none #0<br />
<br />
MSD [02:00] 3.00 000000:03 LUN 0<br />
MSD READ_CAPACITY [02:00] 3.00 00000:03 lun 0 block-count 250006982948<br />
Trying partition: 0<br />
type: 32 lba: 16384 'mkfs.fat' ' bootfs ' clusters 261116 (4)<br />
Trying partition: 1<br />
type: 32 lba: 16384 'mkfs.fat' ' bootfs ' clusters 261115 (4)<br />
Read config.txt bytes 1247 hnd 0x252<br />
xHC-CMD err: 13 type: 1 [02:00] 3.00 00000:03<br />
FAT read failed @ 123896<br />
Block device timeout<br />
Boot mode: SD (01) order f<br />
Failed to open device: 'sdcard' (cmd 371a0010 status 1fff0001)<br />
Failed to open device: 'sdcard' (cmd 371a0010 status 1fff0001)<br />
Boot mode: RESTART (0f) order 0<br />
Boot mode: USB-MSD (04) order f1<br />
<br />
<br />
Then the other screen:<br />
<br />
Raspberry Pi 4 Model B - 8GB<br />
bootloader: 69471177 2025/05/08<br />
update-ts: 1755048332<br />
<br />
board: rev d03115 0014 serial 4cf0723 d2:d8:72:u3:82:10<br />
boot: mode SD 1 order f14 retry 1/1 restart 34/-1<br />
SD: card not detected<br />
part: 1 mbr [0x0c:00004000 0x83:00104000 0x00:0000000 0x00:0000000]<br />
fw: start.elf fixup.dat<br />
net: down ip: 0.0.0.0 sn: 0.0.0.0 gw: 0.0.0.0<br />
tftp: 0.0.0.0 00:00:00:00:00:00<br />
display DISP0: HDMI HDP=1 EDID: ok #2 DISP1: HPD=0 EDID=none #0<br />
<br />
USB3[3] 00281203 connected enabled<br />
USB3 root HUB port 3 init<br />
MSD [02:00] 3.00 000000:03 register MSD<br />
MSD [02:00] 3.00 000000:03 LUN 0<br />
MSD READ_CAPACITY [02:00] 3.00 00000:03 lun 0 block-count 250006982948<br />
Trying partition: 0<br />
type: 32 lba: 16384 'mkfs.fat' ' bootfs ' clusters 261116 (4)<br />
Trying partition: 1<br />
type: 32 lba: 16384 'mkfs.fat' ' bootfs ' clusters 261115 (4)<br />
Read config.txt bytes 1247 hnd 0x252<br />
xHC-CMD err: 13 type: 1 [02:00] 3.00 00000:03<br />
FAT read failed @ 123896<br />
Block device timeout<br />
Boot mode: SD (01) order f<br />
Failed to open device: 'sdcard' (cmd 371a0010 status 1fff0001)<br />
<br />
<br />
Any help...? I really like this case...<!-- migrated from Comments; original IP: 136.61.208.161 --></div>136.61.208.161