View source for X630-Hardware

==Interface==
[[File:X630-diagram.png|800px]]

==10-pin functional connector==
{| class="wikitable"
! Pin No. !! Pin Name !! Function !! Note
|-
| 1 || 3V3 ||  3.3V output  ||  3.3V
|-
| 2 || HDET ||  HDMI input detect (high level ) ||  3.3V
|-
| 3 || IR ||  Infrared signal ||  3.3V
|-
| 4 || INT ||  Interrupt Output signal – active high (Level) ||  3.3V
|-
| 5 || RESET ||  System reset input, active low ||  3.3V 
|-
| 6 || A_SCK ||  I2S/TDM Bit Clock signal (BCK) ||  3.3V
|-
| 7 || A_WFS ||  I2S Word Clock or TDM Frame Sync signal (LRCK) ||  3.3V
|-
| 8 || A_OSCK ||  Audio Oversampling Clock (MCLK) ||  3.3V
|-
| 9 || A_SD ||  I2S/TDM data signal (Data) ||  3.3V
|-
| 10 || GND ||  Ground ||  0V
|}

==X630 Reset Setting==
'''Note: Software reset only exists in V1.3 version, this function is no longer reserved in V1.5'''
[[File:X630-V1.5-VS-X630-V1.3.jpg|700px|none|X630 V1.5 vs X630 V1.3]]

[[File:Dip-switches.jpg|none|dip switch]]
{| class="wikitable"
! SELECTION !! SWITCH SETTINGS !! 
|-
|  Hardware reset || HW = 1 || SW = 0
|-
| Software reset || HW = 0 || SW = 1
|}

[[File:X630-Reset-01.jpg|none|800px|X630 dip switch setting]]

Explain：
* Hardware reset: After starting RASPISTILL or RASPIVID <span style="color:red;">once</span> then you will need to reboot Raspberry Pi to restart it again (Please use when operating system cannot control the X630 module via GPIO509)
* Software reset: Starting RASPISTILL or RASPIVID <span style="color:red;">multiple times</span> and don't need to reboot Raspberry Pi
* Default setting is 'Hardware reset';
* Please remove the yellow protective film before change dip switch.

== Mechanical Drawing==
[[File:X630-mechanical-drawing.png|x630 mechanical drawing]]


Return to [[X630]]

<comments/>