Difference between revisions of "X630"
Line 30: | Line 30: | ||
* 4 x M2.5*6 Screw | * 4 x M2.5*6 Screw | ||
* 1 x M2.5 Nut | * 1 x M2.5 Nut | ||
+ | |||
+ | |||
+ | ==How to install X630== | ||
+ | [[File:X630安装图-2000x2000.jpg|800px|How to install X630]] | ||
+ | |||
+ | ==Match Metal Case== | ||
+ | Please refer to [[X630-C1]] | ||
==FAQ== | ==FAQ== | ||
Line 44: | Line 51: | ||
A: It is SH1.0 10Pin connector. | A: It is SH1.0 10Pin connector. | ||
− | |||
− | |||
− | |||
− | |||
− | |||
<!--Add review function! --> | <!--Add review function! --> | ||
<comments /> | <comments /> |
Revision as of 16:39, 28 October 2021
Contents
Overview
The X630 hdmi to csi module is a bridge module that converts HDMI stream to MIPI CSI-2, which enables your Raspberry Pi to accept HDMI video and audio streams and process them as incoming data source.
Features
- Specifically designed mounting hole for the Raspberry Pi
- HDMI to CSI-2 bridge chip: Toshiba TC358743XBG
- Video Formats Support (Up to 1080P)
- CSI-2 Transmit Interface MIPI CSI-2 compliant (Version 1.01 Revision 0.04 -2 April 2009)
- CSI-2 connector: 15 pin FPC with 1.0 mm pitch
- Able to start RASPISTILL or RASPIVID multiple times and no reboot required
- Easily fixed on Raspberry Pi and DIY your pefect case
User Manual
Packing List
- 1x X630 HDMI to CSI-2 Module
- 1x X630-A1 Board
- 1 x FPC cable(5cm length)
- 1 x FPC cable-for backup(15cm length)
- 2 x F/F M2.5*17mm Spacer
- 4 x M2.5*6 Screw
- 1 x M2.5 Nut
How to install X630
Match Metal Case
Please refer to X630-C1
FAQ
Q: What to do if there is no video output?
A: 1. When use the PI-KVM, please set the dip switches at the back of X630 to HW mode(Hardware reset mode). Pull the HW switch to 1 and pull the SW switch to 0.(Our default mode is SW mode.) Please set the switches at power off status. (For PiKVM usage, you will need to turn off SW reset DIP switch and turn on HW reset DIP switch prior to connecting the CSI cable to your Pi4.)
2. Software reset uses GPIO 509 to reset operation through GPIO. Please refer to wiki: X630-Software
Q: Which connector model is compatible with 10pin functional connector?
A: It is SH1.0 10Pin connector.
Enable comment auto-refresher
Anonymous user #5
Permalink |
Anonymous user #4
Permalink |
Anonymous user #3
Permalink |
Walker
Anonymous user #2
Permalink |
Anonymous user #2
Permalink |
Walker
Anonymous user #1
Permalink |
Lisa