X12-A1
Contents
Safety Instructions & Warnings
⚠ It is essential to read and understand these safety instructions and warnings before charging your batteries.
⚠ Lithium Polymer and Li-ion batteries are volatile. Failure to read and follow the instructions below may result in fire, personal injury, and damage to property if charged or used improperly.
⚠ Never make a wrong polarity connection when charging or discharging battery packs. Always double-check the polarity of the battery's connector to ensure that "+" is connected to "+" and "-" is connected to "-".
⚠ Do not mix and use old batteries with new batteries, or batteries with different brand names.
⚠ Lithium batteries have a limited cycle life. Please replace old batteries with new ones when they reach their service life or when they are two years old, whichever comes first.
⚠ When charging the Battery Pack, please place the battery in a fireproof container. Do not leave the UPS shield on wood material or carpet unattended.
⚠ Keep this product away from children to ensure their safety.
Overview
The X12-A1 is a 4-cell parallel 18650 battery holder designed to accommodate four 18650 batteries. Each battery is protected by a resettable ultra-low resistance fuse to prevent over-discharge. It features four XH2.54 connectors for easy integration with UPS HAT models such as the X1209 and X1203, and supports a stackable design, allowing for capacity expansion through multiple bases.
Features
- Parallel Capacity Expansion: Can accommodate four 18650 batteries connected in parallel, directly increasing power supply capacity.
- Independent Protection: Each battery is equipped with an ultra-low internal resistance resettable fuse to prevent over-discharge.
- Plug and Play: Provides four XH2.54 connectors, compatible with specified UPS HATs, requiring no modifications.
- Stacking Design: Supports multiple stacks (requires the X12-A1 stacking kit), flexibly expanding total power capacity.
- Compatible Models: X1209 UPS HAT (top-mounted Raspberry Pi), X1203 UPS HAT (bottom-mounted Raspberry Pi).
- Core Application: The X12-A1 provides a backup battery expansion solution for the aforementioned UPS HATs.
Technical specification
| Ports & Connectors |
XH2.54 2Pin parallel interface x 4 4-cell 18650 battery socket x1 |
| PCB Dimensions |
93.9mm x 77.1mm |
Packing List
- X12-A1 Base Kit
- X12-A1 18650 battery holder (4-cell parallel) x1
- 2-pin 2.54mm pitch male-to-male cable AWG18 30cm x2
- X12-A1 Stackable Kit - For use with X12-A1 base kit
- X12-A1 18650 battery holder (4-cell parallel) x1
- 2-pin 2.54mm pitch male-to-male cable AWG18 10cm x2
- Spacer M/F 22mm x4
- Screw M2.5x5mm x4
- Screw nut M2.5 x4
User Manual
- X12-A1 Hardware Guide:X12-A1 Hardware
FAQ
Q1: Question 1
A: Place the answer here.
Enable comment auto-refresher